Description

Diamond mounted points are used for jig, internal grinding and precision grinding of small holes in carbides, glass, ceramics, sapphire and many of the tough, super alloys presently being machined. CBN mounted points are used similarly on tough, high carbon, high chrome steels. These are readily available in sizes varying from 1.0 mm to *0 mm.
Grit Size: *0 / **0 (Rough), **0 / **0 (Medium), **0 / **0 (Fine), or as specified.

Recommended Use : Low wheel speed is one of the major causes of poor performance in super abrasive products like Diamond or CBN. Wheel loading and heat build-up are common signs of low RPM. The recommended speed for Electroplated Diamond Internal Grinding Wheel is ***0 to ***0 m/min and for Electroplated CBN Wheel is ***0 to ***0 m/min. The suggested feed vary from 0.**5mm to 0.*5mm depending on the material ground. Coolant should be used wherever possible, but can be used dry successfully.

Internal grinding is arguably the most challenging of all grinding applications. In no other type of grinding can the entire range of parameters change from one job to the next. Therefore, it is necessary to consider the specifics of each job individually in order to arrive at the wheel best suited for the job.
In order to maximize performance capabilities and profit margins, choosing the correct wheel for a job is extremely important. Unfortunately, this isn't always the easiest decision to make, as many factors play into such a selection. One must consider material to be ground, size of area to be ground, amount of stock to be removed, finish desired, machine capabilities and a number of other factors.

This grinding wheel head can be served to polish as well as grind. It can polish any coarse surface quickly and precisely.